WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

3D MODEL BUILDING, COLORING & REPAIR TOOLS

3D Printable Enclosure Builder

Design a case and lid for an electronics board, battery or other component. Use your measurements or review suggestions from a spec sheet, then place mounting posts, port openings and vents.

Model workerConnecting…
0Model queueChecking wait time…

New model project

Instructions

Design a 3D printable electronics enclosure with a fitted lid, mounting posts, vents and accessible ports. Enter dimensions or review a spec sheet.

Saved projects

Loading…

Your build table

Create a part, gear, enclosure, or photo model, or open a saved project. Progress, validation results, versions, and the public Generated Model Library link appear here.

BROKEN PART REPAIR

Rebuild the damaged area

Use a straight-on photo of matching features. Select a good half, quarter, or smaller region to mirror. Quarter and selected-region modes keep the rest of the part. Adjust the axes and review the copied details before approving.

Choose the intact side
Rebuilt reference

Select the good and damaged areas, then preview the rebuild.

Upload a reference image first.

OPTIONAL PHOTO SCALE

Use a quarter for scale

Place a US quarter about half an inch beside the part without touching it. Photograph directly overhead, with the coin and measured face in the same plane. Use the coin's outside edge, not its inner design. Align the part with the photo edges for easier measuring.

Best for flat brackets, covers, and key fobs. Thickness still needs a separate measurement. Scale estimates do not correct reconstruction errors or guarantee mounting-hole fit. Applying the crop clears old brushes and requires a fresh mirror preview.

Upload a reference image, then mark the quarter and part.