WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

HOMEBREW / 3D PRINTING CONVERSATIONS

How to reduce stringing without ruining your retraction settings

Practical 3D printing help, settings, projects, and advice from fellow makers.

Print troubleshooting

P0k3sm0t
Fine hairs between separate towers do not automatically mean you need more retraction. Use a small repeatable test so each adjustment answers one question. A CONTROLLED TROUBLESHOOTING ROUTINE 1. Save the current project and filament profile. Record the spool, nozzle, temperature, and retraction settings. 2. Check the spool's drying instructions and compare against known-good dry filament if possible. Moisture can look like a retraction problem. Clean residue from the nozzle using the printer manufacturer's procedure. 3. Start from a profile intended for your actual extruder and material. A Bowden retraction distance is not a safe universal starting point for a direct-drive hotend. 4. Print the same two-tower test. Adjust temperature within the filament manufacturer's range, then compare stringing, surface quality, and bonding. Do not keep lowering temperature if extrusion becomes unreliable. 5. Tune retraction distance in small steps, then speed separately. Stop if extrusion starts late after travel, the extruder clicks, or the filament is being damaged. 6. Only then compare wipe and travel-routing options. Do not disable collision-avoidance lifts simply to hide strings. Keep the best result rather than the most extreme setting. Photograph each sample with its settings written beside it. A slightly cleaner tower is not an improvement if the real part now has gaps after every travel move. TRY IT HERE Use Slicer Studio to save the working filament settings and compare a fresh slice. See the filament storage guide if a spool performs differently after sitting open. Reply with your best and worst samples, extruder type, filament, temperature, retraction distance, and speed. That gives other makers a useful comparison rather than a mystery photo. Reference: Prusa's stringing and oozing troubleshooting. Its printer-specific values should not be copied onto unrelated hardware.
Sign in to reply

Edit post