A dry-box humidity monitor is a useful first ESP32 accessory: it gives you a small enclosure, a sensor mount, and a real measurement to troubleshoot without controlling a printer's heaters or motors.
A STARTER PARTS PLAN
• An ESP32 development board supported by your chosen software.
• A documented temperature/humidity breakout, such as a supported SHT3x-D module. Check the breakout's supply and signal requirements, not only the sensor chip's name.
• A suitable low-voltage supply, wiring, connectors, and a nonconductive enclosure.
• Optional display or Home Assistant integration after the basic readings work.
BUILD IN STAGES
1. Read the board and sensor documentation. Choose available I2C pins and compatible voltage levels; do not copy pin numbers from a different ESP32 board without checking.
2. Use the sensor's official ESPHome component example as a starting point, adapting it to your board. Keep secrets in your own private configuration.
3. Test temperature and humidity readings on the bench. Compare with another instrument and allow readings to settle; disagreement is a measurement problem to investigate, not a reason to hide it with a guessed offset.
4. Design a ventilated sensor holder. Keep it away from the ESP32's own warmth, direct heater airflow, and loose desiccant. Route the cable so it does not create a large leak in the box.
5. Record readings before opening the box, after opening, and after resealing it. The pattern is more useful than one impressive number.
This monitors air conditions; it does not directly measure water inside filament or prove that a spool has been dried. It is not a thermal safety controller.
Design the holder in Model Studio or your CAD application, then check its size and print orientation in Slicer Studio.
Share the enclosure design, board/sensor models, placement, and measurement comparisons. Remove Wi-Fi passwords and API secrets.
References: ESPHome ESP32 support and SHT3x-D sensor documentation. See also the filament storage guide.
HOMEBREW / 3D PRINTING CONVERSATIONS
Build an ESP32 dry-box humidity monitor: plan the project first
Practical 3D printing help, settings, projects, and advice from fellow makers.
Projects and makes