WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

HOMEBREW / 3D PRINTING CONVERSATIONS

Elephant foot: measure the bottom before changing the whole model

Practical 3D printing help, settings, projects, and advice from fellow makers.

Print troubleshooting

P0k3sm0t
When the first few layers flare outward but the upper walls look correct, changing the scale of the whole model can spoil the dimensions that already fit. Measure the cooled part and separate a local bottom-edge problem from a general size error.

MAKE A BASELINE

1. Download the original 20 × 20 × 5 mm coupon. Its edges are intentionally square, with no bottom chamfer to conceal the effect. Import in millimeters and keep the 20 × 20 mm face on the bed. 2. Use your normal printer, material, and process. Disable a brim for this comparison if adhesion permits, because a brim can obscure the edge being measured. If you need one, record that and remove it consistently before measuring. No supports are needed. 3. Check first-layer setup and the bed/material profile against your printer's instructions. Excessive first-layer compression and unsuitable bed conditions deserve attention before compensation is used to disguise them. Do not blindly change probe offsets or firmware calibration. 4. Let the coupon cool. Measure X and Y near the base and again near the upper straight walls. Record the measurement height and repeat at several positions. Avoid putting the caliper jaws across a corner, seam, or remaining brim. 5. Compare the results with the nominal 20 mm. If the upper walls are also oversized, investigate the wider dimensional problem before adjusting only the bottom. If the base alone flares, a bottom-layer compensation trial may be appropriate.

TRY A SMALL, RECORDED ADJUSTMENT

In Orca-based settings, elephant-foot compensation is a local correction at the bottom layers. A positive compensation reduces that region; it is not a global XY scale correction. Keep the unmodified baseline, change one compensation setting, then preview and print another coupon. Check how many layers the correction affects, and inspect thin bases and attached brims for unintended changes. The right value depends on the machine, material, first layer, geometry, and measurement. This post deliberately supplies no universal compensation number. A cube with an acceptable base does not prove that a tight snap fit or a tiny pin will behave identically; test the critical feature next. Download elephant-foot check kit (ZIP) Download square-edge coupon (STL) Download checksums (JSON) Includes editable OpenSCAD source and a base-versus-top measurement sheet. The mesh and software slicing were checked; physical results have not been tested. Orca precision and compensation documentation PrusaSlicer elephant-foot compensation explanation Reply with your base and upper-wall measurements, first-layer setup, material, compensation value, and a side-on photo. Please include a baseline so others can judge the change.
Sign in to reply

Edit post