WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

HOMEBREW / 3D PRINTING CONVERSATIONS

Under-extrusion: partial clog, feeding problem, or slicer settings?

Practical 3D printing help, settings, projects, and advice from fellow makers.

Print troubleshooting

P0k3sm0t
Missing material is a symptom, not a diagnosis. Increasing flow can hide one problem and create another. Start by separating a geometry or preview issue from an actual extrusion problem, then compare a small repeatable sample.

WORK THROUGH THESE CHECKS

1. Keep the failed file and settings. Look at the layer preview at the height where material is missing. If the intended path is absent before printing, inspect the model, thin features, selected settings, and slice warnings first. If paths exist but the physical print has gaps, investigate extrusion and feeding. 2. Check the obvious profile mismatches: printer, nozzle, filament diameter, material, and selected process. Compare with the last combination that printed reliably. Record recent nozzle, spool, extruder, firmware, and profile changes. 3. Check for a snagged spool, drag in the filament path, debris, or a feeding fault. Inspect accessible mechanical parts only with the machine cooled and powered off; use the manufacturer's procedure for hotend cleaning, unloading, and any work requiring heat. 4. Return to a known manufacturer baseline for that material and nozzle. Do not simultaneously change temperature, retraction, flow ratio, and speed. A successful print after four changes does not identify the cause. 5. Print the supplied 30 × 20 × 4 mm slab flat on its broad face. Use the same saved profile for each comparison, no supports, and enough top layers to close the surface. Verify the preview actually has a closed top before blaming physical gaps on a clog. 6. Record where gaps appear: from the first layer, only after retractions, after the machine warms up, or mainly on fast infill. If reducing extrusion demand fixes the sample, investigate the filament/hotend flow limit and feeding before treating it as proof of a blocked nozzle. 7. If the same known-good profile and material now fail, follow the printer maker's nozzle and feed-system troubleshooting. Do not drill a nozzle, force a cleaning needle into an incompatible hotend, or copy another printer's disassembly instructions.

WHAT THIS SAMPLE CAN TELL YOU

The solid slab gives repeated walls and a top surface to compare. It is not a calibrated flow instrument. Do not derive an exact flow multiplier from one wall measurement or conclude that every gap has the same cause. A large high-flow print may still reveal a problem the small sample does not. Download under-extrusion check kit (ZIP) Download comparison slab (STL) Download checksums (JSON) Includes editable CAD and a worksheet for baseline, single change, and result. Geometry and software slicing were checked; there has been no physical print test. Prusa under-extrusion guide for MK2.5/MK3-family printers Prusa under-extrusion guide for Nextruder printers Those are model-specific references, not universal servicing instructions. In your reply include the printer/nozzle, material, symptom timing, preview screenshot, physical photo, baseline settings, and the single change you tried.
Sign in to reply

Edit post