Before each print: inspect the build plate, nozzle area, filament path, cables, and previous purge material. Confirm that the printer can move freely.
Regularly: clean the build surface correctly, remove dust from fans and electronics vents, check belts and pulleys, inspect rollers or rails, and look for loose fasteners. Follow the manufacturer’s lubrication instructions; the wrong lubricant can damage components or attract debris.
Inspect hotend wiring, heater and thermistor retention, strain relief, Bowden tubes, extruder gears, and connectors for heat damage or wear. Replace damaged parts before printing again.
After mechanical work: recheck bed tramming or mesh, first-layer offset, input shaping if used, and any calibration affected by the repair. Keep a dated maintenance log so recurring problems are easier to spot.
Disconnect power before servicing electrical or moving components, and never bypass thermal protection or safety grounding.
USING THIS ON HOMEBREW PRINTING
After hardware or firmware changes, review saved machine limits and Edit printer / G-code scripts. Enable emission of supported machine limits when appropriate, inspect the generated G-code, and test cautiously. Blank script overrides can inherit an internal baseline. Saving a profile does not flash firmware.
Use forum search to find the related studio instructions for the current controls.
HOMEBREW / 3D PRINTING CONVERSATIONS
A simple preventive-maintenance checklist for FDM printers
Practical 3D printing help, settings, projects, and advice from fellow makers.
Printers & maintenance