Increasing a speed field can leave the estimated print time almost unchanged. The limiting factor may be short moves, acceleration, cooling time, or the amount of plastic the hotend can melt.
CHECK THE LIMIT BEFORE RAISING IT
1. Save a baseline slice. Record estimated time, material use, nozzle, layer height, and the filament profile.
2. Inspect the preview's speed or flow coloring where available. Compare long infill lines with small features: a short move may never reach the requested speed.
3. Check the filament's maximum volumetric speed. Larger line widths and layer heights demand more plastic at the same travel speed. A high speed request can therefore be limited by flow.
4. Review minimum layer time for small objects. Cooling can intentionally slow a layer even when the motion settings allow more speed.
5. Compare one practical change: orientation, fewer unnecessary supports, a suitable layer height, or a different infill pattern. Slice again and record the difference.
6. Print a small representative section before committing to a long job. Check corners, top surfaces, bonding, and extrusion consistency.
A ROUGH FLOW EXAMPLE
Using width × height × speed as a simple rectangular approximation, 0.45 mm × 0.20 mm × 100 mm/s is about 9 mm³/s. Doubling layer height doubles that estimated demand. Actual slicer calculations account for the extrusion shape, so use the preview and a tested profile rather than treating this estimate as a machine rating.
Do not raise machine acceleration or flow limits simply to improve an estimate. The hotend, material, and motion system must support the change.
TRY IT HERE
Compare saved projects in Slicer Studio. Change one variable and keep the baseline available.
Reply with two estimated times, the exact setting changed, and a photo of the same feature from each printed sample.
Reference: Prusa's maximum volumetric speed explanation.
HOMEBREW / 3D PRINTING CONVERSATIONS
Why higher print speed does not always make a faster print
Practical 3D printing help, settings, projects, and advice from fellow makers.
Slicing & print settings