WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

HOMEBREW / 3D PRINTING CONVERSATIONS

0.4 mm versus 0.6 mm nozzles: compare detail and print time fairly

Practical 3D printing help, settings, projects, and advice from fellow makers.

Slicing & print settings

P0k3sm0t
A 0.6 mm nozzle can change how a part is produced, but it does not guarantee a faster print or identical detail. Compare the same job with sensible profiles for each nozzle. A FAIR TEST 1. Extract the comparison tile and read its feature map. Thin bars and posts deliberately expose features that may widen, merge, or disappear with different extrusion widths. 2. Save separate projects with the correct physical nozzle diameter and corresponding printer/filament settings. A slicer selection cannot change the nozzle installed on the printer. 3. Keep the same model, material, orientation, and intended surface thickness. Compare physical wall and top/bottom thickness, rather than assuming equal wall/layer counts produce equal structures. 4. Choose suitable layer height, line width, and tested flow limits for each setup. Do not lift the hotend's volumetric limit just to make an estimate attractive. 5. Inspect both previews. Record missing or altered thin features, estimated time, material use, and whether supports differ. 6. After an appropriate physical nozzle change and first-layer checks, print both trials. Record actual time and mass separately from estimates, and photograph matching features. The default tile is 60 × 35 × 8 mm. Its four nominal bar widths are 0.4, 0.6, 0.8, and 1.2 mm, ordered from low Y to high Y. It is a detail comparison, not a tensile-strength test. Download nozzle comparison kit (ZIP) Download release checksums (JSON) Includes editable SCAD, STL, a feature map, and blank comparison worksheet. Geometry checks passed; no physical speed, quality, or strength results are pre-filled. Share both profiles and comparable photos if you can. Use Slicer Studio to inspect the difference. Reference: Prusa's nozzle-type guidance.
Sign in to reply

Edit post