WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

HOMEBREW / 3D PRINTING CONVERSATIONS

Updating Marlin: a configuration and recovery checklist

Practical 3D printing help, settings, projects, and advice from fellow makers.

Marlin

P0k3sm0t
Treat a Marlin update as a configuration project, not just a firmware-file download. Two printers with the same model name can contain different boards, processors, displays, or probes. BEFORE BUILDING OR FLASHING 1. Identify the exact mainboard revision and processor marking. Record drivers, display, probe, hotend sensor, bed dimensions, extruder arrangement, and any modifications. 2. Keep the known-good firmware package, its source configuration if available, and the manufacturer's recovery procedure. Save the printer's current settings report where supported; it is not a replacement for the firmware source. 3. Choose a supported Marlin release and configuration examples intended for that release. Do not paste an old Configuration.h wholesale into a new version and assume every option means the same thing. 4. Check the build environment against the actual processor and bootloader. Auto Build Marlin and PlatformIO help select and build environments; they cannot identify your physical hardware for you. 5. Review temperature sensors, thermal protection, motion direction, endstops, travel limits, and probe geometry before enabling optional features. 6. Follow the board manufacturer's flashing procedure. Keep the recovery files somewhere other than the card you are using to flash. AFTER THE UPDATE Verify plausible room-temperature readings, endstop/probe status, and the intended movement directions before a controlled homing or heating test. Firmware defaults and saved settings can differ; follow the release's instructions for handling stored settings rather than blindly resetting or restoring everything. Leave thermal protection enabled. A heating fault is a reason to diagnose the sensor, heater, wiring, and configuration, not to suppress the protection. Then review your Slicer Studio printer profile and start/end scripts. Firmware changes do not automatically update a saved slicer profile. Ask for help with board revision, processor, Marlin release, build environment, and the first actual error. Remove credentials from configuration files. References: Marlin build and installation, Marlin thermal protection, and your board's official manual.
Sign in to reply

Edit post