WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

HOMEBREW / 3D PRINTING CONVERSATIONS

Klipper tuning: pressure advance, input shaping, and what to check first

Practical 3D printing help, settings, projects, and advice from fellow makers.

Klipper

P0k3sm0t
Pressure advance and input shaping solve different problems. Keep a known-good printer configuration and change one system at a time so you can tell which adjustment helped. BEFORE EITHER TEST Confirm the printer moves correctly, extrudes reliably, and has a sound mechanical setup. Save printer.cfg and the working slicer profiles. Use a known filament and the actual nozzle. Follow Klipper's complete test instructions rather than borrowing another printer's tuning values. PRESSURE ADVANCE: EXTRUSION DURING SPEED CHANGES Pressure advance helps control extrusion as the toolhead accelerates and slows down. Its value depends on the extruder, nozzle, filament, temperature, and flow conditions. Establish extrusion calibration and printing temperature first. It cannot fix a slipping extruder or wet filament. INPUT SHAPING: MOTION RESONANCE Input shaping addresses ringing from the motion system. Use the documented measurement or test-print method for your hardware. Higher acceleration can still introduce smoothing or exceed the machine's physical abilities. Revisit the calibration after changes that materially affect the moving system. A REPEATABLE WORKFLOW 1. Record the symptom and print a baseline part. 2. Complete the relevant Klipper calibration and restore the temporary test state as its documentation directs. 3. Save the chosen value in the intended configuration or filament profile. Check whether slicer start G-code overrides it. 4. If both systems need tuning, evaluate input shaping and acceleration, then recheck pressure advance under the resulting conditions. 5. Print the original comparison part and inspect corners, repeated features, and extrusion after travel. In Slicer Studio, use settings appropriate to your Klipper machine. A calibration model and a firmware tuning sequence are separate things: do not assume importing a model automatically varies the parameter. Reply with Klipper version, extruder/nozzle, material, the symptom, and before/after photos. Remove keys and other private information from configuration excerpts. References: Klipper pressure advance and Klipper resonance compensation.
Sign in to reply

Edit post