A good-looking print can still refuse to fit. Separate the size the design needs from the clearance the printed assembly needs.
START WITH A SMALL FIT COUPON
1. Measure the real mating part in several places. Record diameter, thickness, hole spacing, and the orientation in which the printed part will be used.
2. Model only the critical interface: one hole, a short socket, a pin, or a small section of the joint. Label each trial size so the samples cannot be mixed up.
3. Print several nearby clearances using the intended printer, filament, nozzle, and orientation. There is no universal clearance that works for every material and joint.
4. Let the pieces cool before comparing. Test the function: sliding, rotating, locating, or snapping together. Measure the printed outside dimensions and the hole separately.
5. Check whether only the bottom edge is tight. First-layer bulging can obstruct an otherwise usable fit; investigate that before resizing the entire part.
6. Carry the successful interface into the full design and print one complete sample before making a batch.
RADIAL AND DIAMETRAL CLEARANCE ARE DIFFERENT
For a 10.00 mm shaft in a 10.40 mm hole, diametral clearance is 0.40 mm. The nominal gap on each side is 0.20 mm when centered. Write down which measurement you mean when sharing results.
Avoid scaling the whole model to repair one hole: it also changes mounting distances and outside dimensions. Keep the original design and make a named revision.
TRY IT HERE
Use Model Studio for a measured part, then inspect dimensions and slice in Slicer Studio. Generated geometry still needs a physical fit test.
Reply with nominal and measured sizes, the intended fit, material, and print orientation. A short table of trial sizes is especially helpful.
Reference: Prusa's modeling guidance and tolerances.
HOMEBREW / 3D PRINTING CONVERSATIONS
3D printed holes too small? A practical fit and clearance test
Practical 3D printing help, settings, projects, and advice from fellow makers.
Design & CAD