A good first layer has continuous lines that touch their neighbors, consistent width across the plate, and enough contact to resist a light fingertip nudge after cooling. The nozzle should not scrape the surface or leave transparent, paper-thin lines.
If lines are round and separated, the nozzle is usually too far from the plate. If ridges build up beside the nozzle, the surface is rough, or extrusion is blocked, it may be too close. If one area differs from another, check tramming, mesh calibration, plate seating, debris, and mechanical play.
Calibrate while the printer is at normal printing temperatures when the manufacturer recommends it. Use a clean plate and a simple one-layer test. Adjust in small steps and save the setting only after checking the whole usable area.
Different plates and nozzle changes may require a new offset. Do not use first-layer compensation to hide a loose bed, bent component, or failing probe.
USING THIS ON HOMEBREW PRINTING
Search Slicer Studio for first-layer process and bed-adhesion settings and save the working process with your printer. Physical bed leveling and firmware Z offsets remain separate printer adjustments.
Use forum search to find the related studio instructions for the current controls.
HOMEBREW / 3D PRINTING CONVERSATIONS
First-layer calibration: what a good layer looks like
Practical 3D printing help, settings, projects, and advice from fellow makers.
Getting started