WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

About this model

Designed by dsully_90

CTC Prusa Y Bearing Block. Original creator notes: Upgrade to the existing y axis plywood bearing block. The little plywood plate that holds the bearing is a couple mm too long along its axis enabling the bearings to move during rapid direction changes despite how tight the zip ties are. This is accurate to the bearing and press fits in very tightly. Uses existing holes to mount to the base of the bed carriage. Holes for zip ties are also there but doesn't necessarily need them as the curved walls and tight long ways fit hold the bearings very secure. Not sure if it will fit other i3 builds but is made for the current CTC prusa setup. Hope it helps and enjoy! PS: This was all part of preventing slippage on the y axis that was causing shifting layers. Turns out the biggest culprit was the timing belt pulley not being fully secured to the motor shaft. Make sure you tighten those grub screws very tight! Original design: CTC Prusa Y Bearing Block Creator: dsully_90 Source: https://www.thingiverse.com/thing:1734519 Original license: CC BY 3.0 — https://creativecommons.org/licenses/by/3.0/ Shared unchanged from the owner’s downloaded archive. Model files are unmodified; preview resized for display. No affiliation or endorsement implied.

Printer: Use a compatible profile for your own printer
Slicer: Not specified · Material: Not specified · Nozzle: Not specified