WELCOME TO THE WORKSHOP

Welcome back.

Sign in to upload models and follow your prints.

About this model

AI STL Studio enclosure example: closed body and removable vented lid, with top wire access above both header rows and a single side DC power opening. USB stays enclosed; remove the lid for USB access. No shields or battery are included. Assembled outside size: 84.58 x 64.34 x 32 mm. Walls, floor and lid are 2 mm. Four 5 mm mounting posts have 2.5 mm blind screw pilots. The slip-fit lid uses 0.25 mm clearance. Top wire slots are 8 mm wide; the side power opening is 16 mm diameter. This vented enclosure is not airtight or waterproof. Downloads: body STL, separate lid STL, and a combined print-layout STL containing both pieces. Use either the combined layout OR the individual pieces. Print the body floor-down and the lid flat with its locating lip upward; flip the lid over to assemble. Preview board/connector guides are illustrative and are not included in the STL. FIT-CHECK PROTOTYPE: PCB outline, mounting positions and header locations follow Arduino's official Uno Rev3 A000066 Eagle CAD. Component-height allowance, power-jack vertical center and plug housing clearance still require a physical check on your board. Check screw fit, clone differences and wire routing before a final print. This example has not been physically printed or fit-tested. All three STL files passed watertight mesh checks. The combined layout was test-sliced with OrcaSlicer: approximately 41.05 g and 2 hours 35 minutes with the tested PLA settings; your printer and settings will change these figures. Board reference: https://docs.arduino.cc/hardware/uno-rev3/ Official CAD source: https://docs.arduino.cc/static/6bb7a3ca51ebee82a252f60c0b418787/A000066-cad-files.zip Shared as a free AI-generated model under CC0.

Printer: Use a compatible profile for your own printer
Slicer: Not specified · Material: Not specified · Nozzle: Not specified