About this model
Designed by CapnBry
Customizable V-Slot Power Plug Cover/Mount. Original creator notes: EDIT: Probably a bad idea to use this switch. I've had two of the switches burn out and melt the switched side of the switch contact, same one both times despite making all new crimped connectors the second time with 14AWG THHN. Both times the current draw was under 2 amps at the socket. **This plug is a fire hazard, do not use.** A simple cover for the [ubiquitous fused power jack with switch](http://amzn.to/23iqmN7). It mounts vertically into the V-Slot using 2x M5x10mm socket cap screws into T-nuts in the extrusion. The wires simply extend out of the bottom and can be used to mount to 20mm or 40mm wide extrusion. The two screw holes for attaching the plug are 3.5mm diameter countersunk so use roughly M3x10mm flat head screws to secure it. #6-32 screws also will fit (close fit). Printed in [ProtoParadigm Sapphire Ingeo PLA](http://www.protoparadigm.com/ingeo-pla/sapphire-PLA-1KG). # Print Settings Printer: C-Bot Resolution: 0.3mm Infill: 15% Notes: I was going to print it with 4 perimeters and 4 top 4 bottom solid layers (which would make it solid plastic, no infill) but it feels pretty strong with my "draft" settings of 2 perimeters, 3 top 2 bottom solid layers and 15% infill so I didn't reprint it. No supports are needed, however your printer must be able to bridge the 9.3mm gap to close the top. Original design: Customizable V-Slot Power Plug Cover/Mount Creator: CapnBry Source: https://www.thingiverse.com/thing:1633449 Original license: CC BY 3.0 — https://creativecommons.org/licenses/by/3.0/ Shared unchanged from the owner’s downloaded archive. Model files are unmodified; preview resized for display. No affiliation or endorsement implied.
Printer: Use a compatible profile for your own printer
Slicer: Not specified · Material: Not specified · Nozzle: Not specified