MeshRight

Drop a 3D model here

MeshRight checks it, tells you what is wrong, and fixes it so it prints. It stays on this computer.

STL, 3MF, OBJ, PLY, GLB, glTF, OFF, AMF, USD or USDZ, or a scanner point cloud (XYZ, ASC, PTS, E57, LAS, LAZ).

Several files? Choose or drop them together to fix them all at once.

Help

Report a problem

MeshRight puts together what we need to look into it. Nothing is sent until you press Send in your email app.

What goes in the report

  • The last error messages MeshRight showed
  • The steps you took on this model (the History list)
  • MeshRight version, browser and operating system
  • The model's name, size and triangle count, not the model itself

Steam Vibe Ltd is registered with the Information Commissioner's Office, ICO Reg. ZC095648. If you include your model, it is used only to reproduce the fault. It is never shared, distributed or sold, and it is deleted once the fault is fixed.

Clean up

Checking what needs doing…

Still broken after cleaning? Make Solid rebuilds the whole model as one closed solid. Detail finer than about 0.2 mm is softened.

Which printer do you use?

MeshRight uses it to check the model fits, and to suggest sensible sizes. You can change it any time.

Fix several files

Best way to print

Trying different ways to place it…

Support amounts are estimates for comparing options; your slicer makes the real supports.

Make a bust

For a scan of a head, or head and shoulders. Closes the opening at the neck, cuts the ragged bottom off flat, adds a base and sizes it.

Stand the head upright first. If it is lying down, use Which way is up?

Make a part

Builds a new, separate piece that sits snugly on the blue area, like a cover, a pad or a grip that follows the curve of the surface. Example: loop round the back of a phone holder to get a rubber pad that fits it exactly.

The piece opens as a new model next to this one (see the tabs at the top). This model is not changed.

3MF in colours

Groups the scan's colours into a few print colours and paints every triangle, so Bambu Studio, PrusaSlicer and OrcaSlicer open it ready for a multi-colour printer. In the slicer, give each colour a filament.

Fewer colours give cleaner areas. Four suits most scans; use as many as your printer has filaments.

Hollow for resin

Makes the inside hollow to save resin, keeping walls of this thickness, with drain holes at the bottom so trapped resin can run out.

The holes go in the underside, so after hollowing the view turns to show them from below.

Ask AI

Ask in your own words, for example "will this print?" or "make it 15 cm tall and fix it". The AI sees the check report, never your model. It can only suggest changes; nothing happens until you press Apply, and each step can be undone.

Connect an AI

Optional. MeshRight works fully without it. Use a service you already pay for, or a free one that runs on this computer (Ollama, LM Studio). Your key is kept on this computer only, in a file only you can read, and is never shown again.

Address (only change for a custom or local service)

Wall thickness

Measuring…

Give it thickness

Turns an open surface, such as a face scan, mask or relief, into a solid shell. The scanned surface stays as it is; the thickness goes behind it.

2 mm suits most filament prints. Use at least twice your nozzle size.

Which way is up?

Finding likely bottoms…