24-tooth spur gear
==================

Module 2, 24 teeth, 8 mm face width and a 5 mm shaft bore.

Generated by the Spur Gear Builder using the included numerical specification. Print flat with the shaft bore vertical. Check bore fit and engagement on a low-load test; the sample has no rated torque or speed.

UNITS AND PRINTING
All model coordinates are millimeters. These are actual generated files and geometry renders, not photographs of printed parts. Closed-mesh and slicing checks do not replace a physical print/fit test. Select your own printer, filament and temperatures. No printer-ready G-code, credentials, private project data or automatic printer commands are included.

DESIGN REFERENCE
Where included, design.json records builder dimensions; it is not a promise that the website imports JSON. generation-report.json records the actual generator result.

LICENSE
These example geometries are made available under CC0 1.0: https://creativecommons.org/publicdomain/zero/1.0/ . Photo-to-3D provenance is included with its public CC0 source. The service and generator software have their own licenses.

Instructions: https://homebrewprinting.com/forum/topic/ai-gear-creator-instructions#studio-samples


SPUR GEAR BUILDER — RECREATE THIS SAMPLE

1. Start a new Spur Gear Builder project. Set Teeth 24 and Face width 8 mm.

2. Choose Size by > Module (mm) and enter 2. Choose Round bore, Shaft bore 5 mm and Bore allowance 0.

3. Leave both hubs completely at 0. Under Meshing & fit choose Pressure angle 20 degrees, Tooth thinning 0 and Mating gear teeth 0. Leave Design notes blank.

4. Wait for the calculated preview, then select Generate gear STL. Download and inspect the 52 mm outside diameter, 48 mm pitch diameter and 8 mm face width.

5. Print flat, bore vertical. Verify tooth engagement and bore fit on a low-load prototype.

Verified through the ordinary browser form, server queue, worker and saved STL download on October 25, 2026. Geometry and slicing checks do not replace a physical print, fit or scan test. design.json is a settings reference, not an importable website project.
