SPUR GEAR BUILDER — RECREATE THIS SAMPLE 1. Start a new Spur Gear Builder project. Set Teeth 24 and Face width 8 mm. 2. Choose Size by > Module (mm) and enter 2. Choose Round bore, Shaft bore 5 mm and Bore allowance 0. 3. Leave both hubs completely at 0. Under Meshing & fit choose Pressure angle 20 degrees, Tooth thinning 0 and Mating gear teeth 0. Leave Design notes blank. 4. Wait for the calculated preview, then select Generate gear STL. Download and inspect the 52 mm outside diameter, 48 mm pitch diameter and 8 mm face width. 5. Print flat, bore vertical. Verify tooth engagement and bore fit on a low-load prototype. Verified through the ordinary browser form, server queue, worker and saved STL download on October 25, 2026. Geometry and slicing checks do not replace a physical print, fit or scan test. design.json is a settings reference, not an importable website project.