GEARWORKS — RECREATE THIS SAMPLE

1. Start a new Gearworks project and choose Internal ring & pinion.

2. Set Pinion teeth 18, Ring teeth 48, Module 1.5 mm and Face width 7 mm. The sample uses 7 mm, not the initial 8 mm form value.

3. Set Pressure angle 20 degrees, Tooth thinning per part 0.1 mm, Pinion bore 5 mm, Bore allowance 0.2 mm and Ring backing 4 mm. The resulting pinion bore is 5.2 mm. Leave Project notes blank.

4. Select Preview gear set. Inspect both Assembled and Print layout. Confirm the reported shaft center distance is 22.5 mm, then Generate gear set STL.

5. Download either the combined layout OR gear set ZIP. The two parts are separated for printing, not in assembly positions. Use the supplied assembly dimensions/transforms. Print flat and test engagement and fit; no torque or wear life is rated.

Verified through the ordinary browser form, server queue, worker and saved STL download on October 25, 2026. Geometry and slicing checks do not replace a physical print, fit or scan test. design.json is a settings reference, not an importable website project.
