SIGN & KEYCHAIN — RECREATE THIS SAMPLE 1. Start a new Sign & keychain project. Choose Rounded rectangle, Width 54, Height 30, Base thickness 5 and Corner radius 4 mm. Leave Raised detail height 0.8, Border width 0, and clear Words. 2. Choose One keyring hole after setting the outside width. Confirm X -21, Y 0 and Diameter 4 mm. Leave symbols, pictures and QR off. 3. Expand Hardware pockets & fasteners and choose + Magnet. Select Open pocket and Round. Set Diameter 10, Hardware thickness 3, Fit allowance 0.3, X 0, Y 0 and Rotation 0 degrees. Do not use Fit thickness: the sample is already 5 mm thick. 4. Select Update 3D preview. Confirm a 10.3 mm diameter, 3.3 mm deep recess with 1.7 mm of floor remaining. Check the review checkbox, then Generate sign / keychain STL. 5. Print pocket-up. Insert and secure your own nominal 10 x 3 mm magnet afterward. This is an open recess, not a snap fit or enclosed insert. Verified through the ordinary browser form, server queue, worker and saved STL download on October 25, 2026. Geometry and slicing checks do not replace a physical print, fit or scan test. design.json is a settings reference, not an importable website project.