HOMEbrew Printing — Herringbone gear example Generated by the website's Spur Gear Builder, using design.json. Original sample geometry, free to use, modify and redistribute under CC0 1.0: https://creativecommons.org/publicdomain/zero/1.0/ Contents: herringbone-gear-24t-30deg.stl, recipe.txt (all fields and exact recreation steps), design.json (settings reference), generation-report.json (dimensions), preview.webp (actual mesh render), workflow-check.json, README.txt and checksums.json. 24 teeth; normal module 2 mm; normal pressure angle 20 degrees; helix 30 degrees; right on the lower half; the upper half reverses; 12 mm width; 5 mm round bore; no bore allowance, thinning or hubs. Outside diameter 59.426 mm, pitch diameter 55.426 mm. The image is a render of the exact STL, not a photograph of a print. STL does not preserve the preview's display color. Print flat with the bore vertical; inspect the first layer and overhangs in your slicer. Pick your own printer, filament, layer height, walls, infill and supports. No G-code or hardware settings are supplied. Match normal module, normal pressure angle and helix magnitude, with opposite hands for a parallel-shaft mate. Align the herringbone center planes. Each half reverses at the gear midpoint with no center gap. Test bore clearance and engagement physically. Zero thinning/allowance demonstrates nominal geometry, not guaranteed printed fit. Torque, speed, fatigue life and wear are not rated. Instructions: https://homebrewprinting.com/forum/topic/ai-gear-creator-instructions Builder: https://homebrewprinting.com/ai-stl-studio