HELICAL GEAR — RECREATE THIS SAMPLE

1. Open Model Studio and select Spur Gear Builder. Start a new design.
2. Set Tooth style = Helical. Set Helix angle = 30 degrees and Helix direction = Right.
3. Set Teeth = 24, Face width = 12 mm, Size by = Normal module (mm), and module = 2.
4. Choose Round bore, Shaft bore = 5 mm, Bore allowance = 0 mm.
5. Leave ALL top and bottom hub fields at 0: diameter, extension, teeth and thinning.
6. Under Meshing & fit, set Normal pressure angle = 20 degrees, Tooth thinning = 0 mm, Mating gear teeth = 0. Leave Design notes blank. Project name is optional.
7. Select Update 3D preview, inspect the actual teeth, then Generate gear STL. Download the finished STL.

Expected measurements:
  Normal module: 2 mm; normal pressure angle: 20 degrees
  Teeth: 24; helix angle: 30 degrees; hand: Right
  Pitch diameter: 55.425626 mm
  Outside diameter: 59.425626 mm
  Face width / total height: 12 mm; straight shaft bore: 5 mm
  Transverse module: 2.309401 mm
  Transverse pressure angle: 22.795877 degrees

Print flat on a circular end face, with the bore vertical. Select your own printer and filament and inspect the sliced toolpaths. No machine-specific G-code is included.

For a same-size parallel-shaft mate, regenerate with the same settings but Left hand. Nominal shaft center distance is 55.425626 mm. Mating gear teeth only calculates measurements; it does not generate another gear. Helical teeth create axial thrust; provide an appropriate bearing arrangement. This zero-thinning example is for inspecting geometry. Choose tooth thinning and bore allowance for your measured printer fit, then print a small fit test.

Verified through the ordinary browser form, isolated server queue, real worker and saved STL download on October 26, 2026. Images render this exact downloadable mesh. Software geometry/slicing checks do not replace a physical print or load test. design.json is a settings reference, not an importable website project. STL uses millimeters and contains no colors.
