Low-voltage lighting planner
Release 2026-10-24-v1

Use an appropriate ready-made low-voltage supply and a documented LED/controller combination. This worksheet is not a wiring diagram for mains, heater outputs, or arbitrary printer boards. Obtain voltage and maximum current from the actual strip/controller specification. Power in watts = voltage in volts x current in amps; include controller load and documented supply headroom. Do not power an LED strip directly from a GPIO. Check switching device, wiring, protection, heat, grounding/logic-level requirements, and moving clearance against the hardware documentation. No universal current per LED is assumed.

USING THIS KIT
1. Read the matching forum post and this README.
2. Extract the ZIP. Edit any SCAD source in OpenSCAD and render before exporting.
3. Import STL in your slicer using millimeters and place the bottom on the plate.
4. Select YOUR printer, nozzle, filament and process; inspect supports and preview.
5. Print a small trial and record actual results in the worksheet.

VALIDATION
Included meshes have been rendered and checked for a closed, consistently wound single solid and stated overall dimensions. This is not a physical print, fit, airflow, electrical, or strength validation. No printer-ready G-code or vendor profiles are included. Blank worksheets contain no claimed results.

LICENSE
Original Homebrew Printing geometry, source and blank worksheets in this kit are dedicated under CC0 1.0. External documentation and hardware designs are not included or relicensed.
