ESP32 camera planning and generic mount
Release 2026-10-24-v1

Generic 40 x 30 x 29 mm L-bracket: 4 mm walls, two 4.5 mm base holes 20 mm apart, and an upright slot 4.4 mm wide with centers at Z14 and Z23 mm. This is not an ESP32-CAM board-specific case. Adapt fasteners and fit without shorting a PCB or trapping antenna/camera cables. Select exact board/pin/supply configuration from its documentation; no universal pinout YAML is provided. Test one viewer first. A stream URL is different from a camera setup page.

USING THIS KIT
1. Read the matching forum post and this README.
2. Extract the ZIP. Edit any SCAD source in OpenSCAD and render before exporting.
3. Import STL in your slicer using millimeters and place the bottom on the plate.
4. Select YOUR printer, nozzle, filament and process; inspect supports and preview.
5. Print a small trial and record actual results in the worksheet.

VALIDATION
Included meshes have been rendered and checked for a closed, consistently wound single solid and stated overall dimensions. This is not a physical print, fit, airflow, electrical, or strength validation. No printer-ready G-code or vendor profiles are included. Blank worksheets contain no claimed results.

LICENSE
Original Homebrew Printing geometry, source and blank worksheets in this kit are dedicated under CC0 1.0. External documentation and hardware designs are not included or relicensed.
