Bracket layout comparison
Release 2026-10-24-v1

Two original 30 x 20 x 25 mm illustrative brackets compare a plain corner with two triangular gussets. They are geometry samples, not rated supports. Both have a nominal 4.5 mm base hole at X20/Y10 and an upright hole at Y10/Z17. Choose part="plain" or "gusset" in SCAD. Keep print orientation, material, fasteners and fixture consistent for comparison; do not claim a strength gain without a controlled physical test. Never use an unknown bracket for a suspended, safety-critical or heavy load.

USING THIS KIT
1. Read the matching forum post and this README.
2. Extract the ZIP. Edit any SCAD source in OpenSCAD and render before exporting.
3. Import STL in your slicer using millimeters and place the bottom on the plate.
4. Select YOUR printer, nozzle, filament and process; inspect supports and preview.
5. Print a small trial and record actual results in the worksheet.

VALIDATION
Included meshes have been rendered and checked for a closed, consistently wound single solid and stated overall dimensions. This is not a physical print, fit, airflow, electrical, or strength validation. No printer-ready G-code or vendor profiles are included. Blank worksheets contain no claimed results.

LICENSE
Original Homebrew Printing geometry, source and blank worksheets in this kit are dedicated under CC0 1.0. External documentation and hardware designs are not included or relicensed.
